Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Knoxville?
Spring repair in Knoxville typically costs $180-$340 for a single spring, and most of that job is a straight spring replacement rather than a repair. If both springs are replaced together as a matched pair, which is the usual approach on a standard two-spring door, expect roughly twice that range. The written estimate you get on site sets the final price, and every estimate we provide is free.
We’re Easton Garage Door Service, and springs are one of the most common calls we handle. Our technicians have up to 11 years of experience, so they’ve seen every spring configuration that shows up on Knoxville doors. Call (855) 965-2742. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- A single torsion or extension spring replacement in Knoxville runs $180-$340.
- A matched pair is usually about double that, since both springs are replaced at once.
- Old, mismatched, or rusted springs can push the job toward the higher end of the range.
- Written estimates are free, and the estimate sets the price.
- Springs are under extreme tension and are not a do-it-yourself job.
Spring Replacement Cost Breakdown (2026)
Here’s how spring replacement pricing typically breaks down for Knoxville homeowners. These are estimated ranges for common spring work, not exact quotes. Every job gets a written estimate before any work begins.
| Service | Typical Estimated Range | Notes |
|---|---|---|
| Single spring replacement | $180-$340 | One torsion or extension spring, including the spring and labor |
| Matched pair replacement | About twice the single spring range | Both springs replaced together, the standard approach on a two-spring door |
| Spring repair (re-tensioning, adjustment, hardware) | $180-$340 | When the existing spring can be corrected rather than replaced |
| Cable repair | $130-$250 | Often paired with spring work, since cables carry the same load |
| Roller replacement | $110-$220 | Worn rollers are frequently found during a spring job |
| Garage door repair (general) | $150-$600 | Broader repairs that may include springs plus hardware |
The biggest driver is how many springs your door uses. Most modern doors in Knoxville have one or two torsion springs mounted above the door, though some older doors still use extension springs that stretch along the tracks. A two-spring door almost always gets both springs replaced at the same time, because the springs have taken the same wear together and one new spring against one tired spring throws the door off balance.
Spring type and size matter too. A heavier door, such as a double-car insulated door, needs heavier springs, and heavier springs cost more than lighter ones. If the job also turns up worn cables, a bent track, or bad rollers, those add to the total but rarely more than the ranges above suggest.
What Affects Spring Replacement Pricing in Knoxville
Knoxville sits in a humid, four-season climate, and that shows up in the condition of the springs we find. Summer heat and humidity work on steel, and springs that live in an unconditioned garage collect moisture and rust faster than springs in drier parts of the country. Here’s what moves the price up or down on a Knoxville spring job.
- One spring or two. A single spring door costs the single-spring range. A two-spring door is usually replaced as a pair, which lands around twice that. There’s no honest way to give one flat price for both, so ask which setup your door has before you compare quotes.
- Spring size and door weight. A wide, insulated double door needs heavier springs than a single-car door. Heavier springs mean more material cost, and the difference shows up in the estimate.
- Condition of the surrounding hardware. Springs live next to cables, drums, and bearings. If a cable is frayed or a bearing is grinding, fixing it during the same visit makes sense. Cable repair typically runs $130-$250 and roller replacement $110-$220 when those get added.
- Rust and corrosion from the humid climate. Springs on a door facing west or sitting in a damp, shaded garage around Knoxville tend to show surface rust sooner. That can mean a spring that’s harder to work loose and a longer job, which nudges the price toward the top of the range.
- Door age and opener condition. On older homes, springs are often the first part of a longer list. If the opener is also straining, we can look at both in one visit. Opener repair ranges from $120-$320, and it’s worth knowing before you commit.
- Access and ceiling height. A tight garage with a low ceiling or stored items crowding the door makes the job slower. Clear space in front of the door helps and can shorten the visit.
How to Save on Spring Replacement
Spring replacement isn’t a job where shopping on price alone pays off, but there are real ways to keep costs reasonable without cutting corners.
- Replace both springs at once when you have two. It sounds like more money up front, but replacing one spring and then the second a few months later usually costs more in total than doing the pair together.
- Bundle related repairs into one visit. If your cables or rollers are also worn, fixing them during the spring job avoids a second service call later. Ask for the combined estimate so you can see the whole picture.
- Get a written estimate before work starts. A clear, itemized estimate protects you from surprises. Ours are free, and the estimate sets the final price. Call (855) 965-2742 to book one.
- Catch it early. A door that’s starting to feel heavy or open unevenly often has a spring on the way out. Addressing it before the cable or track takes damage keeps the job in the lower part of the range.
- Keep the garage dry. Reducing moisture in the garage, especially on the door that faces the weather, slows rust on the springs and helps them last longer.
Why We Don’t Recommend Replacing Springs Yourself
Torsion springs hold a massive amount of stored energy, even when the door is down. When they fail during a DIY attempt, injuries are serious. This is one of the few garage door jobs where the advice is genuinely simple: leave it to a trained technician. Extension springs are also under heavy tension, and the safety cables and hardware around them need to be set correctly.
We work safely with the right tools and the right technique. Our technicians have up to 11 years of experience, and they know how to release tension, swap the spring, and rebalance the door so the opener isn’t fighting a door that’s out of adjustment. That balance check is a big part of why a spring job done right lasts.
How a Typical Spring Replacement Visit Works
When we come out for a spring call in Knoxville, the first step is a look at the whole door, not just the broken spring. We check the springs, cables, drums, rollers, tracks, and the opener. Then we walk you through what we found and what it takes to fix it, along with a written estimate.
If you approve, we replace the spring or springs, set the tension correctly, and rebalance the door so it lifts and lowers smoothly. We also test the opener and the safety reverse. A door that felt heavy or noisy before the visit should feel noticeably different afterward. The goal is that the door is right the first time, not that you’re calling us back in a month.
Most spring jobs are straightforward and can be handled the same day when you call in. Same-day service depends on scheduling, so calling early helps.
Repair or Replace: Which Makes Sense?
If the door itself is in good shape, replacing just the spring is almost always the smarter call. A spring is a wear part. Doors and panels last far longer than springs do, so a $180-$340 spring job on a door with years of life left beats a full replacement.
Where it gets murkier is an older door with a cracked panel, a bent track, or rust working through the steel. Panel replacement runs $250-$500, and track realignment $120-$240. When several of those problems stack up, a new door installation in the $700-$2200 range can make more sense. We’ll tell you honestly which side of that line your door is on. Repair when repair makes sense, replace when it doesn’t.
Brands We Work On
Springs are springs, but the door around them isn’t always the same, and knowing the brand helps us get the right spring and the right tension settings faster. We’re trained and experienced on eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. If your door or opener carries one of those names, we already know the platform. If it’s another brand, we can still take a look. We work on the brand you already have rather than steering you toward something new.
FAQs – Spring Replacement Cost
How much does a garage door spring replacement cost in Knoxville?
Spring repair in Knoxville typically costs $180-$340 for a single spring. If your door has two springs and they’re replaced as a matched pair, expect roughly twice that range. The written estimate sets the final price. Call (855) 965-2742 for an exact quote, and estimates are free.
Is it cheaper to replace one spring or both?
Replacing both springs at once is usually cheaper overall, even though the pair costs about twice a single spring. Two springs wear at the same rate, so replacing one and then the other months later typically costs more in total than doing the pair in one visit. A single-spring replacement sits in the $180-$340 range, and a pair runs about double. Call (855) 965-2742 and we’ll tell you which setup your door has.
Can you come today for a broken spring?
Same-day spring replacement is often possible in Knoxville when you call in, but it depends on the day’s schedule. Call (855) 965-2742 to check. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Does a broken spring need to be repaired or replaced?
Most broken springs need replacement, not repair, and that’s the $180-$340 range for a single spring. A spring can sometimes be adjusted or re-tensioned rather than replaced, and that falls in the same range. A technician can tell you which is right within a few minutes of looking. Call (855) 965-2742 to book a free estimate.
What else might need fixing when a spring breaks?
When a spring fails, several nearby parts are worth checking. Cable repair typically runs $130-$250, roller replacement $110-$220, and a broader garage door repair covering springs plus hardware runs $150-$600. Getting the full picture in one estimate helps you plan. Call (855) 965-2742 and we’ll walk you through it.
Ready for a Free Spring Replacement Estimate?
A broken or sagging spring doesn’t get better on its own, and a door that’s out of balance puts extra strain on the opener every time you use it. Whether you’re in a home near downtown Knoxville or anywhere across the area, we’ll come out, look at the whole door, and give you a clear written estimate before any work starts. Our technicians have up to 11 years of experience across eight major brands, and we treat opener repair and door repair as one connected job rather than two separate calls.
Call (855) 965-2742 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. If your call comes outside dispatch hours, we’ll book you into the next opening.
Written by the team at Easton Garage Door Service.
Pricing reflects the Knoxville market as of 2026. Easton Garage Door Service offers free estimates – call (855) 965-2742.
What Our Customers Say
"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Carlos Herrera"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Paige Meyer"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Kurt Ziegler